A Father Christmas magic card.  I first cut the front of the card to the size I wanted and die cut the centre out.  I then cut 2 pieces of white card the same size.  Next I stamped the image LOTV on to white card and coloured and also stamped the same image on to acetate using stazon.  The two images were lined up with the acetate on top and sellotaped at the top with thin strong tape. I cut through both layers to make them smaller than the base card and also lined them up with the appeture of the front of the card.  The coloured image was placed behind one of the white card base and the acetate on top of it.  Next I added a small amount on card at the bottom of the coloured piece to act as stoppers when the card is pulled up.  I stuck the two base cards together using thin shakertape, at the bottom and sides and a small amount at the top at each side making sure that the picture layers would pull up easily.  To finish I add the top layer again with shakertape and added a sentiment and ribbon so that the card could be pulled up easily.